Difference between revisions of "Shovel"
From A Wiki in the Desert
m (Fixed links from "Cuttable stone" to "Cuttable Stone" and "Medium stone" to "Medium Stone") |
m (Adding "T8 Below" tag, replaced: {{Languages}} → {{Languages}} {{T8 Below}}) |
||
| Line 1: | Line 1: | ||
{{Languages}} | {{Languages}} | ||
| + | |||
| + | {{T8 Below}} | ||
{{Merge|Shovels}} | {{Merge|Shovels}} | ||
Revision as of 00:59, 19 August 2019
|
It has been suggested that this article or section be merged with Shovels. (Discuss)
|
| Shovel | ||
|---|---|---|
 |
||
| (Item) | ||
|
||
|
A Shovel is a reliable blacksmithed metal shovel. It is superior to the Slate Shovel and Iron Shovel. It does not break and improves digging efficiency based on the quality.
Sources
Produced at a Anvil and requires Blacksmithing and Advanced Blacksmithing
Cost
Uses
- Group digs to dig for Cuttable Stone, Medium Stone, gypsum and bauxite
- Gather dirt from the ground.
- Mining Camp
Research and Tuition
- 40 Shovels (25 8500+ quality, 10 9000+ quality, 5 9500+ quality) needed for Advanced Blacksmithing 2 research
- 100 Shovels (9500+ quality) needed for Storage Improvements 2 research
Blacksmithing a Shovel
- Put your metal on your anvil.
- Your goal is to get a lower dent in the middle, get metal to the back sides and make a flat tongue at the front.
- Use a Shaping Mallet and try moving the metal from the area which will be the tongue in the end to the middle/back of the piece and then push it to the sides so it ends up with the height you need there.
- Try using force medium (7) to low (3) to get that done and shift a lot between the model and your work piece.
- Start at the front part where the tongue will be and try to push metal to the back.
- Hit in the front, but not the edge because you want the metal. This creates a higher ridge a bit behind the front.
- Push that back with 2 side strokes / a middle stroke if necessary and repeat.
See also